Studer Innotec CFC-01, RCC-01, Cxxxx-S, C-IP23 manual Temperature sensor CT-35, Xp-Compact

Page 19

STUDER INNOTEC

XP-COMPACT

4.11 The Remote Control RCC-01

As an option, a Remote Control can be connected to the XP-COMPACT. All operating controls and displays except from level adjustment are available on the Remote Control. The Remote Control is supplied with a 20m long cable. It can as long as 40m. The Remote Control is suitable for surface mounting on the wall or on to a switch board. It is fixed with 4 screws. The XP-COMPACT can also be programmed with the Remote Control. The Programming is descry-bed in the section „Programming“.

The output power and the charging currents are displayed on the Remote Control.

In the Remote Control there is an additional Alarm Contact and a built-in Control Input. These two functions are available through Tip-jack RJ11/4 for use. This Auxiliary Contact is Front / Work Contact (max. 0.5A!), which is independent from the Auxiliary Contact of the XP-

COMPACT. This con-tact is active in case of an alarm of the XP-COMPACT.

The Control Input is connected in parallel to the ON/OFF- push button. The XP- COMPACT can be switched on or off through this input with an impulse button or an impulse contact.

Caution: No external voltage should be connected to this Input Control.

Order Number for Remote Control: RCC-01

Dimensions: H x B x T / 111.5 x 136.5 x 25mm

4.12 The Temperature sensor CT-35

Operating voltage of lead-acid batteries change depends on the temperature. To correct the operating voltages according to the actual temperatures, a temperature sensor can be connected to the

XP-COMPACT.

The compensation through the sensor is –3mV/°C/Cell.

Order Number: CT-35

Dimensions: H x B x T / 58 x 51.5 x 22mm

XP-COMPACT V5.4

21/77

Image 19
Contents Studer Innotec Sine wave Inverter, Battery charger, TransfersystemXP-COMPACT Operating instructions Quality and WarrantyWarranty Disclaimer General InformationLiability Disclaimer Special precautionsIntroduction Principle schematicDescription of the main functions Battery connecting Connections Mounting and installingInstallation place FixingProtection cover of the terminals connections Connection PlanSolar + Connection to the 230Vac-consumer appliances AC Output Pre-installation settingsConnection to battery CablingDisplay and control parameters ControlTransfer ChargerSolar ChargeTurning Knobs Push buttonsInverter Battery charger Equalization charging Default values for battery voltage thresholdsCharging current Transfer systemSet the transfer voltage threshold Fast UPS- Mode for the Transfer SwitchDelayed mode of the Transfer System CompactMultifunctional Contact Solar charge controller optionXP-COMPACT Temperature sensor CT-35Battery voltages and absorption time Programming possible only with the remote control RCC-01Standard setting Reset value default settingsProgramming of the Auxiliary Contact Auxiliary contactTable of voltage and timing threshold PrincipleAuxiliary Contact as generator starter Power cut of the second priority loadsManual operating of Auxiliary Contact Disabling some of the XP-COMPACT functions Diagram of the different modesDeclaration of CE Compliance Installation MaintenanceTechnical Data