STUDER INNOTEC |
The Auxiliary Contact can be operated at any time with the Push Button 21 (AUX. CONTACT). The LED 6 „Contact manual“ lights up as information that the Contact is manually operated, and LED 5 „Contact active“ lights up when the Contact is active. By pushing the Push Button 21 a second time, the Contact is disabled. By pushing it the third time, automatic functions are restored.
5.5Disabling some of the XP-COMPACT functions
Each different function charger, inverter and transfer can be disabled. This is useful for specific applications witch required to disable some of these three functions.
If you press the buttons 19 and 20 more than 2 seconds you can have access to the different possibilities, shown in the following diagram.
In programming mode the display shows only the different types of program with the three LED’s 2, 7 and 9 to each function. To change the type of programming, press shortly the button 20 until you reach the right function used according to the table below. After 10 seconds the
In user mode, the disabled functions are displayed by blinking LED. So you can see which mode is disabled.
5.5.1 Diagram of the different modes
Shows an off LED
Shows a blinking LED
Shows a lighted LED
All the functions are enabled. This is the factory setting.
The inverter is disabled. Only the transfer switch and the charger will work normal- ly.
Inverter and charger are both disabled. Only the transfer switch function is ena- bled in input voltage and frequency is OK
Charger and transfer switch are disabled the inverter will work continuously even if there is a correct AC voltage at the input.
| 25/77 |