Harbor Freight Tools 32206, 32208 manual Figure AA, To Operate The Bandsaw

Page 17

FIGURE AA

FIGURE BB

To Operate The Bandsaw:

1.Before starting the Bandsaw make sure all adjustments are properly made and all of the guards are in place.

2.Before turning on the power, turn the Belt Pulley (23B) by hand to make sure there is no binding of moving parts.

3.Keep the Upper Blade Guide Assembly (See Figure W) down as close to the material being cut as possible.

4.When turning on the Bandsaw, allow the machine to reach its full speed before cutting the material.

5.Do not force the material into the Saw Blade. Light contact with the Saw Blade will permit easier following of the line and prevent undue friction, heating and work-hardening of the Saw Blade at its back edge.

6.Keep the Saw Blade sharp for easier forward pressure when cutting.

7.Move the material slowly and steadily against the Saw Blade.

8.Avoid twisting the Saw Blade when attempting to turn sharp corners. Remember to saw around corners.

SKU 32208/32206 For technical questions, please call 1-800-444-3353.

PAGE 17

Image 17

Contents Wood Bandsaw For technical questions or replacement parts, please callSave this Manual SpecificationsGeneral Safety Warnings and Precautions Industrial Applications Must Follow Osha Requirements Specific Product Warnings and PrecautionsFigure a SKU 32208/32206 For technical questions, please call See Figure D and Hardware Diagram See Figure C and Hardware DiagramUnpacking Operating InstructionsTo Assemble The Motor Onto The Stand See Figure F and Hardware DiagramHardware Diagram To Assemble The Bandsaw Body To The Stand DiagramSee Figure K Figure KFigure L To Install The Saw Blade To Install The Side Panels To The Stand39A. See Figure N Lighted in Figure O stepSee Figures T See Figure RSee Figures T and U To Adjust The Tracking Of The Saw Blade To Adjust The Saw Blade TensionTo Adjust The Upper Blade Guide Assembly To Adjust The Upper Blade Guides And Support BearingsTo Adjust The Lower Blade Guide And Support Bearing REV 04/02 To Adjust The Angle Of The TableTo Attach The Guide Post Guard To Attach The Dust Chute Figure YTo Operate The Bandsaw Figure AATroubleshooting Guide Please Read the Following Carefully REV 03/04 Assembly Diagram aStand Assembly Diagram B Parts List Assembly B Saw Body Parts List Assembly B Saw Body Parts List Assembly C Parts List Assembly D Assembly Diagram E Assembly Diagram F Hardware Diagram Wiring Diagram