Harbor Freight Tools 32208, 32206 manual Figure a

Page 4

2.MAKE SURE THE POWER SWITCH IS IN THE “OFF” POSITION BEFORE PLUGGING IN THE POWER CORD.

3.DO NOT ABUSE THE POWER CORD. Do not use the cord to pull the 3-prong plug from a power outlet. Keep cord away from heat, oil, sharp edges, and moving parts. Replace damaged cord immediately. Route the power cord safely. Protect it from being damaged by other equipment in the shop. Do not route the cord where it can be walked on or tripped over.

4.IF YOU USE AN EXTENSION CORD, MAKE SURE TO USE ONLY UL AP- PROVED CORDS HAVING THE CORRECT GAUGE AND LENGTH.

(SEE FIGURE A.)

FIGURE A

5.MAINTAIN A SAFE WORK ENVIRONMENT. Do not use this product in or near damp or wet areas. Do not expose this product to rain. Keep work area well lit. Make sure there is adequate surrounding work space. Use this product in a well ventilated area. Do not operate this product in the presence of flammable liquids, gases, or dust. To avoid accidental electric shock, do not let your body come in contact with grounded surfaces such as pipes, radiators, ranges and refrigerators.

6.DO NOT FORCE THE EQUIPMENT. This Bandsaw will do the work better and safer at the speed and capacity for which it was designed.

7.KEEP ALL GUARDS IN PLACE AND IN WORKING ORDER.

8.REMOVE ALL ADJUSTING WRENCHES FROM THE BANDSAW BEFORE TURNING IT ON.

9.MAKE SURE THAT WHEN INSTALLING THE SAW BLADE THE SAW TEETH POINT DOWNWARD AND TOWARD THE TABLE (36) OF THE BANDSAW.

SKU 32208/32206 For technical questions, please call 1-800-444-3353.

PAGE 4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents For technical questions or replacement parts, please call Wood BandsawGeneral Safety Warnings and Precautions SpecificationsSave this Manual Specific Product Warnings and Precautions Industrial Applications Must Follow Osha RequirementsFigure a SKU 32208/32206 For technical questions, please call See Figure C and Hardware Diagram See Figure D and Hardware DiagramUnpacking Operating InstructionsHardware Diagram See Figure F and Hardware DiagramTo Assemble The Motor Onto The Stand Diagram To Assemble The Bandsaw Body To The StandFigure K See Figure KFigure L To Install The Side Panels To The Stand To Install The Saw Blade39A. See Figure N Lighted in Figure O stepSee Figures T and U See Figure RSee Figures T To Adjust The Saw Blade Tension To Adjust The Tracking Of The Saw BladeTo Adjust The Lower Blade Guide And Support Bearing To Adjust The Upper Blade Guides And Support BearingsTo Adjust The Upper Blade Guide Assembly To Attach The Guide Post Guard To Adjust The Angle Of The TableREV 04/02 Figure Y To Attach The Dust ChuteFigure AA To Operate The BandsawTroubleshooting Guide Please Read the Following Carefully Stand Assembly Diagram aREV 03/04 Assembly Diagram B Parts List Assembly B Saw Body Parts List Assembly B Saw Body Parts List Assembly C Parts List Assembly D Assembly Diagram E Assembly Diagram F Hardware Diagram Wiring Diagram
Top Page Image Contents