Harbor Freight Tools 32208, 32206 manual Unpacking, Operating Instructions, To Assemble The Stand

Page 6
FIGURE B

UNPACKING

When unpacking, check to make sure all parts shown on the Parts List (pages 20, 22, 23, 24, 25 and 26) are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

OPERATING INSTRUCTIONS

NOTE: For additional references to the parts listed below, refer to pages 20, through 28 of this manual.

To Assemble The Stand:

1.NOTE: During the following 7 steps, loosely fin- ger tighten all Bolts and Nuts.

2.Set the Front and Back Stands (2A, 3A) upright with the two square holes nearest the edge at the top. Attach the Face Plate (1A) over the top

of the Front and Back Stands (2A, 3A), using the Carriage Bolts, Washers, and Nuts (I). (See Fig- ure B and Hardware Diagram.)

3.Attach the two Support Plates (7A) inside each

side of the Front and Back Stands (2A, 3A), us- ing the Carriage Bolts, Washers, and Nuts (I).

(See Figure C and Hardware Diagram.)

4. Attach the Motor Plate Bracket (9A) to the front of the Face Plate (1A) with the raised section of

it towards the middle, using the Carriage Bolts, Washers, and Nuts (I). (Note the loca- tion of the Switch Cover (13A) in relation to the mounting position.)

(See Figure D and Hardware Diagram.)

5.Attach the Stiffening Plate (8A) to the underside and toward the rear of the Face Plate (1A), using the Carriage Bolts, Washers, and Nuts (I). (See Figure D, Assembly Dia- gram A, and Hardware Diagram.)

FIGURE C

FIGURE D

View from

 

Underneath

 

 

REV 03/04; 07/04; 12/05

SKU 32208/32206 For technical questions, please call 1-800-444-3353.

PAGE 6

Image 6
Contents For technical questions or replacement parts, please call Wood BandsawSpecifications General Safety Warnings and PrecautionsSave this Manual Specific Product Warnings and Precautions Industrial Applications Must Follow Osha RequirementsFigure a SKU 32208/32206 For technical questions, please call Unpacking See Figure C and Hardware DiagramSee Figure D and Hardware Diagram Operating InstructionsSee Figure F and Hardware Diagram Hardware DiagramTo Assemble The Motor Onto The Stand Diagram To Assemble The Bandsaw Body To The StandFigure K See Figure KFigure L 39A. See Figure N To Install The Side Panels To The StandTo Install The Saw Blade Lighted in Figure O stepSee Figure R See Figures T and USee Figures T To Adjust The Saw Blade Tension To Adjust The Tracking Of The Saw BladeTo Adjust The Upper Blade Guides And Support Bearings To Adjust The Lower Blade Guide And Support BearingTo Adjust The Upper Blade Guide Assembly To Adjust The Angle Of The Table To Attach The Guide Post GuardREV 04/02 Figure Y To Attach The Dust ChuteFigure AA To Operate The BandsawTroubleshooting Guide Please Read the Following Carefully Assembly Diagram a StandREV 03/04 Assembly Diagram B Parts List Assembly B Saw Body Parts List Assembly B Saw Body Parts List Assembly C Parts List Assembly D Assembly Diagram E Assembly Diagram F Hardware Diagram Wiring Diagram