Harbor Freight Tools 32206, 32208 manual See Figure F and Hardware Diagram

Page 7
Note: Attach both 8A and 9A underneath the Face Plate (#1A) - see Assembly Diagram A on page 20 for clearer view.
REV 03/04; 07/04; 02/05; 12/05

6.Attach one end of the Motor Plate (10A) to the Motor Plate Bracket (9A), using the

Hex Bolts, Washers, Spring Washers, and Nuts (I). (See Figure E and Hard- ware Diagram.)

7.Attach the other end of the Motor Plate (10A) to the rear Support Plate (7A), us-

ing the Hex Bolts, Washers, Spring Washers, and Nuts (I). (See Figure E and Hardware Diagram.)

8.NOTE: Check to make sure the Stand is setting square on the floor. Then, wrench tighten all Bolts and Nuts se- curely.

9.Insert two Lock Pieces (4A) into the two holes located on the underneath of each end of the Front Stand (2A). Insert the remaining two Lock Pieces (4A) into the two holes located on the underneath of each end of the Back Stand (3A).

(See Figure F and Hardware Diagram.)

10.Attach the four Stand Assemblies (II) to the four Lock Pieces (4A). (See Figure

F and Hardware Diagram.)

Side View

(Motor already mounted)

FIGURE E

View from

Underneath

FIGURE F

To Assemble The Motor Onto The Stand:

1.Note: For both the Model 32208 Band Saw and the Model 32206 Band Saw, make sure to attach the Motor Pulley (3D, Model 32208 - part #1C, Model 32206 onto the Shaft of the Motor (11A) before proceeding with the following instructions. Also, for the Model 32208 Band Saw, make sure to attach the Motor Pulley (3D) with its largest diameter closest to the Motor. (See Figure E)

2.Attach the Motor (11A) to the Motor Plate (10A), using the four Hex Bolts, Washers, Spring Washers, and Nuts (IV). Note: Dur-

ing this step loosely finger tighten the Bolts and Nuts. (See Figures G and H on page 8, and the Hardware Diagram on page 27.)

SKU 32208/32206 For technical questions, please call 1-800-444-3353.

PAGE 7

Image 7
Contents Wood Bandsaw For technical questions or replacement parts, please callGeneral Safety Warnings and Precautions SpecificationsSave this Manual Industrial Applications Must Follow Osha Requirements Specific Product Warnings and PrecautionsFigure a SKU 32208/32206 For technical questions, please call Operating Instructions See Figure C and Hardware DiagramSee Figure D and Hardware Diagram UnpackingHardware Diagram See Figure F and Hardware DiagramTo Assemble The Motor Onto The Stand To Assemble The Bandsaw Body To The Stand DiagramSee Figure K Figure KFigure L Lighted in Figure O step To Install The Side Panels To The StandTo Install The Saw Blade 39A. See Figure NSee Figures T and U See Figure RSee Figures T To Adjust The Tracking Of The Saw Blade To Adjust The Saw Blade TensionTo Adjust The Lower Blade Guide And Support Bearing To Adjust The Upper Blade Guides And Support BearingsTo Adjust The Upper Blade Guide Assembly To Attach The Guide Post Guard To Adjust The Angle Of The TableREV 04/02 To Attach The Dust Chute Figure YTo Operate The Bandsaw Figure AATroubleshooting Guide Please Read the Following Carefully Stand Assembly Diagram aREV 03/04 Assembly Diagram B Parts List Assembly B Saw Body Parts List Assembly B Saw Body Parts List Assembly C Parts List Assembly D Assembly Diagram E Assembly Diagram F Hardware Diagram Wiring Diagram