![](/images/new-backgrounds/1240281/24028155x1.webp)
Changing the Charger Module
Caution! Remove DC power and remove batteries when installing the charging module.
1.\Remove the 4 mounting screws that secure the charging module. 2.\Pull the charger module to remove it from the housing.
3.\Insert the replacement charger module into the housing (note the orientation of the guide rails).
4.\Insert the mounting screws (4 pieces) and tighten them to secure the charging module.
Troubleshooting
Power LED off. | DC power fault - check connection to power supply. |
| Ensure PS50 power supply is connected to an AC |
| power source. |
Charge status LED | Battery is not fully inserted. |
does not illuminate. |
|
Battery does not | Battery discharged below 3.0 volts. Try another |
charge | battery. |
Specifications
Battery Type | Up to 2 rechargeable |
Charge Time | 50%=1 hour; 100%=3 hours |
Operating Temperature Range | |
Battery Charging Temperature Range | 0°C (32°F) to 60°C (140°F) |
Storage Temperature Range | |
Dimensions | 44 x 86 x 116 mm (1.8 x 3.4 x 4.5 in.), H x W x D |
Weight | 425 g (15.0 oz.), without batteries or PS50 External |
| Power Supply |
Housing | Cast and extruded aluminum |
Power Requirements | 5.5 V DC, 2.72 A |
3