Multiquip tp24 manual Method, Table from the guide rails. See Figure, Shim may be required

MAINTENANCE

Method 2

This procedure corrects another source of misalignment that occurs when the table’s orientation is not parallel with the guide rails.

1.Use the universal wrench to loosen (but not remove) the fasteners from either end of both guide rails. Move each rail away from the other, so that the horizontal

rollers are clear of the right guide rail. See Figure 23.

HORIZONTAL

GUIDE 1 ROLLER

LEFT

2

HORIZONTAL ROLLER

ROLLER

LOOSEN

CLEARANCE

RIGHT

GUIDE

RAIL

GUIDE

RAIL

Figure 25. Remove Table

3. If the table shifts to the right as it travels away from

the user, a shim needs to be added to the guide roller

furthest from the ruler guide. On the other hand, if

the table shifts to the left, a shim needs to be added

FASTENERS

Figure 23. Roller Clearance

2.Remove rubber cap A on the left side of the table. Loosen the exposed lock nut using a 13mm socket wrench. Use a flat screwdriver to turn the shaft of the roller clockwise to lower it by approximately 3/8 in. (9.5 mm). See Figure 24. Evenly lift up the table to disengage the guide rollers from the left guide rail. Once the guide rollers are clear, shift the table to the right to clear the left horizontal roller of the rail. Remove

the table from the guide rails. See Figure 25.

RUBBER

CAP A

FLAT

SCREW

DRIVER

13MM

SOCKET WRENCH

RUBBER

CAP C

RUBBER

CAP B

Figure 24. Lowering Roller

to the guide roller closest to the ruler guide. Remove

the appropriate guide roller to insert a shim between

the roller and table, then reattach. See Figure 26.

Depending on the severity of the shift, more than one

shim may be required.

4. After adding shim(s), mount the table onto the guide

rails by reversing the instructions in step 2. Move the

rails toward each other to engage the horizontal rollers

to the right guide rail as shown in Figure 22. Realign

the table to the blade using Method 1. Check to see if

any shifting persists. A shift tolerance of 0.2mm (.008

in.) is allowed. A shift in excess of that will require

further adjustment—repeat step 3.

FLAT

ROLLER

GUIDE
ROLLER	HORIZONTAL
SHIM	ROLLER

Figure 26. Add Shims

5.Once alignment is successful, replace saw back into water tray.

TP24 TILE SAW • operation and parts manual — rev. #2 (04/12/12) — page 29