Grizzly G0588 Sliding Table, Components and Hardware Needed Qty, To install the sliding table

Sliding Table

DO NOT use the sliding table until it is adjusted according to the instructions on Page 29. It will not produce accurate cuts until properly adjusted.

Components and Hardware Needed:	Qty
Sliding Table	1
Push Handle M14-2 x 16 w/T-Nut	1
To install the sliding table:

1.Remove the nuts and washers from the long bolts. DO NOT remove the nuts and washers from the shorter bolts.

The sliding table is a very heavy unit. Serious per- sonal injury may occur if safe moving methods are not followed. To be safe, you will need assis- tance and power equip- ment when installing the sliding table.

2.Lift the sliding table onto the table saw as shown in Figure 16.

Note: The long bolts go through the circular holes and the short bolts go into the square holes.

3.Remove the cover plates shown in Figure 17 and remove the cover plate under the other end of the sliding table.

Figure 17. Removing cover plates.

4.Thread the washers and nuts removed in Step 1 onto the long bolts.

5.Slide the T-nut into the sliding table and thread in the handle as shown in Figure 18.

Handle Table Lock

Figure 16. Installing the sliding table.

G0588/G0591 12" Sliding Table Saws

Figure 18. Sliding table handles.

6.The sliding table is unlocked when the table lock is in the position shown in Figure 18. Rotate the table lock 180˚ to lock the sliding table.

-21-