Rip Fence and Scale
Components and Hardware Needed: | Qty |
Aluminium Rip Fence | 1 |
Rip Fence Round Rail | 1 |
Rip Fence Body | 1 |
Rip Fence Lock Handle | 1 |
Square Tube w/Scale | 1 |
Flat Washers 6mm | 3 |
Hex Nuts | 3 |
Cap Screws | 5 |
To install the rip fence: |
|
1.Remove a hex nut and a flat washer from each of the studs in the round rail.
2.Insert the studs into the table as shown in Figure 22, and loosely secure with the hex nuts and a flat washers removed in Step 1.
3.Align the square tube w/scale parallel with the top of the table and secure with the cap screws (see Figure 23). Secure the cap screws in the extension table with
Stop
Screw
Figure 23. Attaching the scale.
4.Thread the rip fence lock handle into the rip fence body.
5.Remove the stop screw from the left end of the rip fence round rail, slide the rip fence body onto the rail and move it all the way to the left.
6.Adjust the nut shown in Figure 24 until the teeth of the pinion gear on the underside of the rip fence mesh with the teeth on the square tube. Tighten the hex nut inside the lip of the table to secure the stud.
Figure 22. Installing the round rail.
Adjusting Nut
Figure 24. Aligning the round rail.
G0588/G0591 12" Sliding Table Saws |