Grizzly G0560 Stand, Components and Hardware Needed Qty, Tools Needed, To assemble the stand

Page 15

Stand
Components and Hardware Needed:	Qty
Rubber Feet	4
Feet Bracket	4
Hex Bolt M6-1 x 20	4
Stand Side	2
Stand Side Brace	2
Stand Top	1
Top Panel “S” Brace	1
Motor Mounting Bracket	1
Carriage Bolt M8-1.25 x 16	16
Hex Nut M8-1.25	20
Flat Washer 8mm	20
Tools Needed:
10mm Wrench or Socket	2
To assemble the stand:

All stand pieces except the rubber feet should be assembled with the M8-1.25 x 16 carriage bolts, M8 hex nuts, and 8mm washers.

1.Attach the stand sides to the stand top as shown in Figure 7. Make sure the side of the stand with the switch cutout is on the same side as the V-belt cutout on the top piece. This will ensure that the switch is in front of the bandsaw. Do not completely tighten the carriage bolt nuts at this time.

Switch Cutout

V-belt Cutout

Figure 7. Stand sides attached to stand top.

2.Place the (4) feet brackets on the stand cor- ners where the rubber feet will be installed.

3.Insert the (4) M6-1 x 20 hex bolts into the rubber feet and attach the feet to the stand corners as shown in Figure 8.

Rubber Foot

Foot Bracket

Figure 8. Rubber foot and foot brackets.

4.Attach the side braces to the stand sides as shown in Figure 9.

Side Braces

Figure 9. Stand braces attached to stand sides.

G0560 Meat-Cutting Bandsaw

-13-

Image 15

Contents MEAT-CUTTING Bandsaw Page Table of Contents Safety Instructions for Power Tools Safety25ft 50ft 100ft Length AMP RatingAdditional Safety Instructions for Meat Saws Commentary General InformationAmperage Draw Circuit RequirementsAmperage Draw Plug-Type Circuit BreakerCircuit Capacity Rewiring To GroundingExtension Cords Machine Features Base Unit Figure SET UPUnpacking InventoryMotor, drive belt and switch pieces Figure Stand Pieces FigureTable, Fence and Grinder Pieces Figure Hardware Recognition Chart Working Clearances Site Considerations Clean UpTo assemble the stand StandComponents and Hardware Needed Qty Tools NeededTo install the switch and power cord Switch & CordTo install the motor MotorWiringBandsaw Unit BeltTo put on the V-belt To install the guards Stand CoversBlade & Table Guards Installing rails on table G0560 Meat-Cutting Bandsaw To install the sliding tableChecking table position G0560 Meat-Cutting Bandsaw Fence To install the fenceMeat Grinder To install the sausage stufferBlade Guard OperationsBlade Tension Blade GuidesChanging Blades Blade TrackingTest Run Support BearingTo cut meat with your bandsaw Cutting MeatWhen cutting bone Cutting Bone Grinding MeatTo use the meat grinder CLEANING/SANITIZING Cleaning the SawTo clean your bandsaw after use Proper Sanitation Lubrication MaintenanceGeneral Table & BladeReference Info Machine Data Sheet G0560 Wiring Diagram G0560 G0560 Main Saw Assembly G0560 Stand & Motor Assembly G0560 Sliding Table Assembly Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog