Grizzly instruction manual Checking table position G0560 Meat-Cutting Bandsaw

2.Slide the bandsaw blade through the slot in the sliding table and place the table on the rollers. Note—Be careful when placing the table on the saw. The other end of the rails are not secured to the table.

3.Secure the force plate under the open edge of the table with the M6-1 x 12 knob screws as shown in Figure 22.

Figure 22. Installing force plate.

4.Secure the rails to the end of the table using the knob screws as shown in Figure 23.

Figure 23. Securing rails in the sliding table.

5.Tighten the rails in place so that they slide in the roller groove.

Note—This table adjustment may take some trial and error. It is best to position the inside rail so the blade is centered in the slot, then squeeze the outer rail into the roller groove and tighten the knob screws. It is important that the rails are secure in the rollers and the blade does not make contact with the table.

6.Check to make sure the rails are in the roller grooves and that the table slides smoothly (Figure 24).

Figure 24. Checking table position.

G0560 Meat-Cutting Bandsaw -19-