Grizzly G0560 instruction manual Stand Covers, Blade & Table Guards, To install the guards

Page 19

Stand Covers
Components and Hardware Needed:	Qty
Tap Screws #6 x 3⁄8"	12
Catch Tabs	12
Stand Covers	2
Tools Needed:
Phillips Head Screwdriver	1

The stand covers need catch tabs installed in all the predrilled holes as shown in Figure 17 & 18.

Figure 17. Stand covers with catch tabs.

Figure 18. Catch tab in place on stand cover.

The stand covers fit inside the stand openings and attach by turning the catch tabs over the edges of the stand.

Blade & Table
Guards
The blade and table guards prevent contami-
nants from falling into the saw.
Components and Hardware Needed:	Qty
Blade Guard	1
Table Guard	1
Knob Screw M6-1 x 12	6
To install the guards:

1.Place the table guard around the bandsaw throat on the top edge as shown in Figure 19.

Figure 19. Table guard installed.

2.Secure the table guard in place with a knob screw on each side of the guard.

3.Place the blade guard around the side of the bandsaw covering the blade as shown in Figure 20.




G0560 Meat-Cutting Bandsaw			-17-

Image 19

Contents MEAT-CUTTING Bandsaw Page Table of Contents Safety Instructions for Power Tools Safety25ft 50ft 100ft Length AMP RatingAdditional Safety Instructions for Meat Saws Commentary General InformationAmperage Draw Circuit RequirementsAmperage Draw Plug-Type Circuit BreakerGrounding Circuit Capacity Rewiring ToExtension Cords Machine Features Base Unit Figure SET UPUnpacking InventoryStand Pieces Figure Motor, drive belt and switch pieces FigureTable, Fence and Grinder Pieces Figure Hardware Recognition Chart Working Clearances Site Considerations Clean UpTo assemble the stand StandComponents and Hardware Needed Qty Tools NeededTo install the switch and power cord Switch & CordTo install the motor MotorWiringBelt Bandsaw UnitTo put on the V-belt Stand Covers To install the guardsBlade & Table Guards Installing rails on table G0560 Meat-Cutting Bandsaw To install the sliding tableChecking table position G0560 Meat-Cutting Bandsaw Fence To install the fenceMeat Grinder To install the sausage stufferBlade Guard OperationsBlade Tension Blade GuidesChanging Blades Blade TrackingTest Run Support BearingTo cut meat with your bandsaw Cutting MeatCutting Bone Grinding Meat When cutting boneTo use the meat grinder Cleaning the Saw CLEANING/SANITIZINGTo clean your bandsaw after use Proper Sanitation Lubrication MaintenanceGeneral Table & BladeReference Info Machine Data Sheet G0560 Wiring Diagram G0560 G0560 Main Saw Assembly G0560 Stand & Motor Assembly G0560 Sliding Table Assembly Warranty and Returns Warranty Card BOX BELLINGHAM, WA Grizzly INDUSTRIAL, INCPage Call Today For a Free Full Color Catalog