Grizzly G0560 instruction manual Bandsaw Unit, Belt, To put on the V-belt

Page 18

Bandsaw Unit

 

Components and Hardware Needed:

Qty

Bandsaw Base Unit

1

Special Hex Bolt M10-1.5 x 16

3

The Model G0529

weighs 127 lbs. Personal injury could occur if the machine is moved without addition- al assistance. Seek help when moving or lifting the machine.

To install the bandsaw unit onto the stand:

1.Place the bandsaw base unit onto the stand as shown in Figure 15. Get help so you do not strain yourself.

Figure 15. Bandsaw unit on stand.

2.Line up the holes in the corner of the stand with the holes on the bottom of the bandsaw unit.

3.Fasten the stand to the bandsaw unit with the (3) M10-1.5 x 16 special hex bolt as shown in Figure 16.

Figure 16. Installing special hex bolt.

V-Belt

Before you put on the V-belt, make sure that the motor pulley and the upper pulley are reasonably aligned. To do this, loosen the setscrew on the motor pulley, adjust the motor pulley so it is in-line with the upper pulley, then tighten the setscrew.

To put on the V-belt:

1.Loosen the (4) motor mount bolts.

2.Raise the motor up and fit the V-belt in the pulley grooves, then let the motor down.

3.Place slight pressure on the motor to tension the belt and tighten the (4) motor mount bolts. Make sure that the motor does not twist and double check the pulley alignment. Adjust the positioning as needed.

4.Check for approximately 1⁄4" deflection. If the belt is not tensioned correctly, repeat steps 1 and 3 until it is correct.

-16-

G0560 Meat-Cutting Bandsaw

Page 17 Page 19
Image 18
Page 17 Page 19
Contents MEAT-CUTTING Bandsaw Page Table of Contents Safety Safety Instructions for Power ToolsLength AMP Rating 25ft 50ft 100ftAdditional Safety Instructions for Meat Saws General Information CommentaryCircuit Breaker Circuit RequirementsAmperage Draw Plug-Type Amperage DrawCircuit Capacity Rewiring To GroundingExtension Cords Machine Features Inventory SET UPUnpacking Base Unit FigureMotor, drive belt and switch pieces Figure Stand Pieces FigureTable, Fence and Grinder Pieces Figure Hardware Recognition Chart Site Considerations Clean Up Working ClearancesTools Needed StandComponents and Hardware Needed Qty To assemble the standSwitch & Cord To install the switch and power cordMotorWiring To install the motorBandsaw Unit BeltTo put on the V-belt To install the guards Stand CoversBlade & Table Guards To install the sliding table Installing rails on table G0560 Meat-Cutting BandsawChecking table position G0560 Meat-Cutting Bandsaw To install the fence FenceTo install the sausage stuffer Meat GrinderOperations Blade GuardBlade Guides Blade TensionBlade Tracking Changing BladesSupport Bearing Test RunCutting Meat To cut meat with your bandsawWhen cutting bone Cutting Bone Grinding MeatTo use the meat grinder CLEANING/SANITIZING Cleaning the SawTo clean your bandsaw after use Proper Sanitation Table & Blade MaintenanceGeneral LubricationReference Info Machine Data Sheet G0560 Wiring Diagram G0560 G0560 Main Saw Assembly G0560 Stand & Motor Assembly G0560 Sliding Table Assembly Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog
Top Page Image Contents