Grizzly G0560 instruction manual Switch & Cord, To install the switch and power cord

Page 16

5.Attach the motor mounting plate to the top panel “S” brace with (2) 516"-18 x 12" carriage bolt, 516" washers and 516"-18 hex nuts (Figure 10).

Figure 10. Motor mounting bracket attached to

the top panel “S” brace.

6.Attach the motor mounting plate with the top panel “S” brace to the inside of the stand as shown in Figure 11.

Figure 11. Top brace to stand top.

7.Turn the stand over on its feet to square out the sides and tighten the remaining loose nuts.

Switch & Cord

 

Components and Hardware Needed:

Qty

Switch

1

Switch Cover

1

Power Cord

1

Tools Needed:

 

Phillips Head Screwdriver

1

To install the switch and power cord:

 

Mount the switch on the stand side with the (2) 10-24 x 1" Phillips screws, 10-24 nuts, and star washers.

1.Place the strain relief into the hole on the stand side. Thread the plastic nut onto the back side of the strain relief.

2.Make sure the plastic setscrew is withdrawn enough to allow the cord to come through the strain relief, then push the end of the cord with the wires through the strain relief.

3.Allow enough room for the red and black wires to reach the switch and the green wire to reach the ground (hole below the switch).

4.Tighten the plastic setscrew to secure the cord in place. Mount the switch and cord to the stand side as shown in Figure 12.

Figure 12. Switch & cord installed on stand.

 

 

 

 

 

 

 

 

 

 

 

 

-14-

G0560 Meat-Cutting Bandsaw

Image 16
Contents MEAT-CUTTING Bandsaw Page Table of Contents Safety Safety Instructions for Power ToolsLength AMP Rating 25ft 50ft 100ftAdditional Safety Instructions for Meat Saws General Information CommentaryCircuit Requirements Amperage Draw Plug-TypeCircuit Breaker Amperage DrawGrounding Circuit Capacity Rewiring ToExtension Cords Machine Features SET UP UnpackingInventory Base Unit FigureStand Pieces Figure Motor, drive belt and switch pieces FigureTable, Fence and Grinder Pieces Figure Hardware Recognition Chart Site Considerations Clean Up Working ClearancesStand Components and Hardware Needed QtyTools Needed To assemble the standSwitch & Cord To install the switch and power cordMotorWiring To install the motorBelt Bandsaw UnitTo put on the V-belt Stand Covers To install the guardsBlade & Table Guards To install the sliding table Installing rails on table G0560 Meat-Cutting BandsawChecking table position G0560 Meat-Cutting Bandsaw To install the fence FenceTo install the sausage stuffer Meat GrinderOperations Blade GuardBlade Guides Blade TensionBlade Tracking Changing BladesSupport Bearing Test RunCutting Meat To cut meat with your bandsawCutting Bone Grinding Meat When cutting boneTo use the meat grinder Cleaning the Saw CLEANING/SANITIZINGTo clean your bandsaw after use Proper Sanitation Maintenance GeneralTable & Blade LubricationReference Info Machine Data Sheet G0560 Wiring Diagram G0560 G0560 Main Saw Assembly G0560 Stand & Motor Assembly G0560 Sliding Table Assembly Warranty and Returns Warranty Card Grizzly INDUSTRIAL, INC BOX BELLINGHAM, WAPage Call Today For a Free Full Color Catalog