Grizzly G0605X/G0606X owner manual Riving Knife, On/Off Switch, Miter Gauge

Riving Knife

Review this section, even if your saw riving knife came pre-installed. You must install the riving knife or the splitter and blade guard before operat- ing the table saw.

Flange Bolt

Stop Paddle

Components and Hardware Needed:	Qty
Riving Knife	1
To install the riving knife:

1.Remove the table insert, blade guard, and splitter—if previously installed.

2.Loosen the hex bolt (Figure 29), insert the riving knife into the bracket slot, and tighten the hex bolt to secure the riving knife.

3.Reinstall and secure the table insert.

Riving Knife

Bracket

Hex Bolt
Figure 29. Riving knife installed.
On/Off Switch
Components and Hardware Needed:	Qty
Safety Pin	1
Flange Bolts M8-1.25 x 25	2
To install the switch:

1.Fasten the switch to the left end of the front rail with two flange bolts, and install the anti- start safety pin as shown in Figure 30.

G0605X/G0606X Extreme Series 12" Table Saw

Anti-Start
Safety Pin
Figure 30. Switch installed.
Miter Gauge
Components and Hardware Needed:	Qty
Miter Gauge	1
Miter Gauge Handle	1
Flat Washer 8mm	1
To install the miter gauge:

1.Install the miter gauge handle and 8mm flat washer onto the miter gauge as shown in Figure 31.

Handle

Washer

Figure 31. Miter gauge installed.

2.Slide the miter gauge into the miter gauge slot to the left of the blade; or store it tempo- rarily on the brackets near the blade angle handwheel.

-25-