Woodstock W1819/W1820 manual e\iXc, 9Xj`Zfekifcj, ON/OFF Switch Starts and stops the motor

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

FG<I8K@FEJ

>\e\iXc

This machine will perform many types of operations that are beyond the scope of this manual. Many of these operations can be dangerous or deadly if performed incorrectly.

The instructions in this section are written with the understanding that the operator has the necessary knowledge and skills to operate this machine. @]XkXep k`d\pflXi\\og\i`\eZ`e^[`]]`Zlck`\jg\i]fid`e^Xep fg\iXk`fe#jkfglj`e^k_\dXZ_`e\

If you are an inexperienced operator, we strongly recommend that you read books or trade articles, or seek training from an experienced Table Saw operator before performing any unfamiliar operations. 8Yfm\Xcc#pfli jX]\kpj_flc[Zfd\]`ijk

I<8;Xe[le[\ijkXe[k_`j\ek`i\`ejkilZ$ k`fedXelXcY\]fi\lj`e^k_`jdXZ_`e\% J\i`flj g\ijfeXc `ealip dXp fZZli `] jX]\kpXe[fg\iXk`feXc`e]fidXk`fe`jefk le[\ijkff[ Xe[ ]fccfn\[% ;F EFK i`jb pflijX]\kpYpefki\X[`e^

9Xj`Z:fekifcj

ON/OFF Switch: Starts and stops the motor.

Safety Pin & Chain: When installed (as shown in Figure 35) disables the switch to prevent accidental startup.

Blade Tilt: To adjust the blade tilt, loosen the blade tilt lock, turn the blade tilt handwheel to position the blade at the desired angle, then tighten the lock shown in Figure 36.

Blade Height: To set the blade height, unlock the blade height lock, turn the handwheel to set the blade height approximately 1⁄4" higher than the workpiece, then re-tighten the blade height lock.

Fence Lock: After adjusting the fence to the desired width of cut, lock it in place by firmly pushing the fence lock down until it stops.

Safety

Pin

OFF

Switch

=`^li\*,. ON/OFF switch disabled.
Blade Height	Blade Tilt	Fence Lock
Lock
	Lock
Blade Height		Blade Tilt
Handwheel		Handwheel
=`^li\*-%Basic table saw controls.

FG<I8K@FEJ

-31-