Woodstock W1819/W1820 manual Glj9cfZbj, DXb`eXGlj9cfZb

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('
Glj_9cfZbj	Prohibition
	Push Stick
When used correctly, a push block reduces the risk of	Zone
injury by keeping hands away from the blade while	Push Stick
cutting. In the event of an accident, a push block often
takes the damage that would have otherwise happened	Supporting
to hands or fingers.
A push block can be used in place of or in addition to	Blade	Push
a push stick for feeding workpieces into the blade. Due	Path
		Block
to their design, push blocks allow the operator to apply	Feeding
firm downward pressure on the workpiece that could not	=`^li\.0% Using a push block and push
otherwise be achieved with a push stick.
	stick to make a rip cut.

The push block design on this page (see =`^li\81) can be used in two different ways (see =`^li\80). Typically, the bottom of the push block is used until the end of the workpiece reaches the blade.

The notched end of the push block is then used to push the workpiece the rest of the way through the cut, keeping the operator's hands at a safe distance from the blade. A push stick is often used at the same time in the other hand to support the workpiece during the cut.

	=`^li\/'. Side view of push block in use.
DXb`e^XGlj_9cfZb	CAUTION: Bottom
	of handle must be
Use this template to make your own push block.	at least 4" above
	bottom of push
	block to keep
	hand away from
	blade.

Handle for firm grip

Make push block with

1⁄2"–3⁄4" thick material

Notch for use as a push stick

4"

CAUTION: Only use hardwood, sturdy plywood, or high-density plastic. Do not use softwood that

may break under pressure or metal that can break 1⁄4"–1⁄2"teeth from the blade!

Lip for pushing workpiece

1⁄2" Grid

9"−10" Minimum Length

=`^li\/(. Template for a basic shop-made push stick (not shown at actual size).

-59-

FG<I8K@FEJ