Woodstock W1819/W1820 manual Zb`e8c`ed\ek, Jk\gj1

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

Jgi\X[\ifiI`m`e^Be`]\ 8c`^ed\ek

:_\Zb`e^8c`^ed\ek
The blade guard spreader and riving knife must be aligned
with the blade when installed. If the spreader/riving knife
is not aligned with the blade, then the workpiece will
before forced sideways during the cut, which will increase			Top Alignment
the risk of kickback.
KffcjE\\[\[	Hkp		Riving
Straightedge .....................................................1
		Bottom Alignment	Knife
KfZ_\Zbk_\jgi\X[\i&i`m`e^be`]\Xc`^ed\ek#[fk_\j\
		Table
jk\gj1

(% DISCONNECT THE SAW FROM POWER!	=`^li\(''% Checking top and bottom
	riving knife parallelism with blade.

J<IM@:<

)% Raise the saw blade to the maximum height so you have easy working access.

*% Place the straightedge alternately against the top and bottom of blade and spreader/riving knife, as shown in =`^li\(''. The spreader/riving knife should be parallel with the blade along its length at both positions, and it should be in the "Alignment Zone," as shown in =`^li\('(.

—If the spreader/riving knife is not parallel with the blade and inside the alignment zone, then it needs to be adjusted. Proceed to 8[aljk`e^8c`^ed\ek instructions.

—If the spreader/riving knife is not parallel with the blade at either the top or bottom, it may be bent.

+% Remove the spreader/riving knife and place it on a flat surface and check to see if the spreader/riving knife lays evenly along its length.

—If the spreader/riving knife does not lay evenly, proceed to 8[aljk`e^9\ekJgi\X[\i&I`m`e^Be`]\ on GX^\-0.

8c`^ed\ek

Qfe\

Jgi\X[\ifi

I`m`e^Be`]\

9cX[\

=`^li\('(% Spreader/riving knife

alignment zone.

-68-