Woodstock ST1000 owner manual Installing Fence, To install the fence

Page 16

Installing Fence

 

Components and Hardware Needed:

Qty

Fence Body

1

Front Angled Rail

1

Front Square Rail

1

Rear Rail

1

Hex Bolts M6-1 x 10

4

Hex Bolts M6-1 x 20

4

Lock Washers 6mm

7

Flat Washers 6mm

7

Knob M10-1.5 x 25

1

To install the fence:

 

1.Secure the rear rail against the rear of the table with the flat un-drilled surface facing up, and install two M6-1 x 20 hex bolts flat washers and lock washers.

2.Attach the front angled rail to the front of the table with M6-1 x 20 hex bolts, flat washers, and lock washers.

3.Attach the square rail to the front angled rail with the M6-1 x 10 hex bolts, lock washers and flat washers (Figure 17).

Figure 17. Installing front rail system.

4.Set the fence on the fence rail to the left of the blade.

5.Secure the fence with the M10-1.5 x 25 knob (Figure 18).

Figure 18. Correctly installed fence.

-14-

ST1000 14" Bandsaw

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Manual Page Table of Contents Model ST1000 Specifications MotorMachine Features Front view of bandsawSafety Instructions SafetyZero Risk Does Not Exist Safety Instructions Power Requirements OperationSetup Items Needed for SetupUnpacking QtyInventory Main Inventory Figure QtyFence Inventory Figure Qty Hardware QtyCleanup Site ConsiderationsFloor Load Necessary SpaceTo install the main body Assembling StandMain Body Components and Hardware Needed QtyMotor & Switch To install the motor and switchTo install the lower blade guide Installing Blade GuidesTo install the upper blade guide assembly To install the table Installing Positive StopTo install the positive stop Installing Fence To install the fenceDust Collection Adjusting Positive StopTo set the positive stop To center track the blade Blade TrackingChanges in the blade tension may change the blade tracking Tensioning Blade Test RunTo tension the bandsaw blade Adjusting Support Bearings To adjust the support bearingsAdjusting Blade Guides To adjust the upper and lower blade guidesCalibrating Table Tilt Scale To calibrate the pointer on the table tilt scaleAligning Table Aligning FenceTo align the miter slot parallel to the bandsaw blade To align the fence parallel with the miter slotMiter Gauge To calibrate the miter gaugeOperation Safety OperationsOverview Straight CutsTo adjust guide post assembly alignment on the guide post Key SwitchGuide Post Blade Lead Table TiltRipping CrosscuttingTo rip with the Model ST1000 To crosscut with the Model ST1000Resawing To resaw a workpieceStacked Cuts Cutting CurvesTo complete a stacked cut Blade Information Blade LengthBlade Width Tooth StyleTooth Pitch Blade CareBlade Breakage Most common causes of blade breakage areTo remove the blade Blade ChangesTo replace the blade Maintenance CleaningSchedule Unpainted Cast IronTroubleshooting ServiceMotor Operation Edge of the cut WorkpieceChecking V-Belt Tensioning V-BeltTo check the V-belt Tools Needed QtyReplacing V-Belt To replace the V-beltWheel Alignment To verify if the upper and lower wheels are copla- narTo Shim a Wheel 110V Motor Wiring 220V Motor Wiring ST1000 Electrical ComponentsST1000 Wiring Diagram Main Breakdown Main Breakdown Parts List DescriptionXPB73M Fence Breakdown & Parts List Safety Labels Breakdown & Parts List Warranty Warranty Registration CommentsBOX BELLINGHAM, WA
Top Page Image Contents