HP C100/110 manual Preparing to Install Your Storage Device, Came with your device

Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

Preparing to Install Your Storage Device

This section describes information that you need to consider and procedures that you need to perform before installing any storage device.

Configuring your Storage Device

Table 13 lists the recommended SCSI IDs for internal storage devices. If an existing device already uses one of the suggested IDs, select an alternate ID.

Table 13	Default SCSI IDs
	Fast/Wide Differential SCSI Devices	SCSI ID
	1st Hard Disk Drive	6
	2nd Hard Disk Drive	5
	3rd Hard Disk Drive	4
	Single-Ended SCSI-2 Devices	SCSI ID
	CD-ROM Drive	2
	DDS-Format Tape Drive	3
	NOTE: The floppy drive is not a SCSI device.
	Set the jumpers and SCSI IDs according to the installation instructions that
	came with your device.

Determining Your Storage Devices Position

Each storage device is restricted as to where in the storage tray it may be installed. Before installing a storage device, use Figure 21 and Table 14 to determine which disk tray position is correct for your device.

Figure 21 shows the storage device positions in the disk tray. Table 14 lists what devices are supported in the different disk tray positions. The numbers in the table’s left column refer to the position numbers in Figure 21.

120