HP C100/110 manual Also, read the ESD Precautions in Appendix a of this guide

NOTICE:

CAUTION:

Changing Your Workstation’s Hardware Configuration

This appendix describes the procedures to change your workstation’s hard- ware configuration. It presents the information in the following sections:

•Checking the SCSI IDs

•Preparing your workstation

•Installing storage devices

•Removing the main tray assembly

•Replacing the main tray assembly

•Installing additional memory

•Installing an EISA or GSC option board

•Changing your monitor type

The instructions in this chapter assume you are using HP-UX version 9.05 or later operating system with HP VUE version 3.0 or later interface.

Your workstation shipped with a package of extra disk slides. Keep the slides in a safe place, you will need them when you add new devices to the storage tray.

Always wear a properly grounded wrist strap when reconfiguring your workstation.

Use the following tools to remove or replace hardware parts when changing your configuration:

•Light-duty flat blade screwdriver with 150 mm (6 in.) blade

•Needlenose pliers

Also, read the ESD Precautions in Appendix A of this guide.

114