HP C100/110 manual Replacing the Battery, Removing the Battery

Changing Your Workstation’s Hardware Configuration

Replacing the Battery

Replacing the Battery

1Remove the main tray as described in Removing the Main Tray Assembly earlier in this chapter.

2Note the orientation of the battery. Make sure that you put the new battery in place with the positive (+) side facing in the same direction.

3Lift the clip and slip the battery out of its holder, as shown in Figure 42.

Figure 46 Removing the Battery

NOTICE:

CAUTION:

ATTENTION:

4Insert the new battery in the same orientation as the old one. (Only use HP part number 1420-0314 or equivalent.)

If you cannot gain access to the battery, you may need to remove an option board. Refer to Installing an EISA or GSC Option Board earlier in this chapter for information on accessing the option boards.

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.

Il y a danger d’explosion s’il y a remplacement incorrect de la batterie. Remplacer uniquement avec une batterie du même type ou d’un type recommandé par le constructeur. Mettre au rébut les batteries usagées conformément aux instructions du fabricant.

5Follow the instructions in Replacing the Main Tray Assembly earlier in this chap- ter to close and restart the system.

154