Setting Up Your Printer

Setting Up a Local Printer Using SAM

If you chose Add Serial (RS-232C) Printer/Plotter in the previous step, more than one serial interface may be listed. The serial interfaces are listed in ascend- ing order. The lowest numbered serial interface corresponds to the lowest num- bered serial connector on your workstation. Choose the serial interface that corresponds to the connector to which you have connected your printer. Place the mouse cursor on the selected serial interface and click the left mouse button.

11Click on OK.

12A window opens. Click on the Printer Name box. Then enter the printer’s name and press Enter.

13Click on Printer/Model Interface.

14A window opens. Move the mouse cursor onto the scroll bar slider at the side of the new window. Press and hold the left mouse button while moving the mouse. When the model name of your printer appears, release the left mouse button.

15Move the mouse cursor to your printer’s model name and click the left mouse button.

16Click on OK.

The window closes and the Add Local Printer/Plotter window becomes visible again.

17If you want your printer to be set as the system default printer, move the mouse cursor to the small box labeled Make this the system default printer and click the left mouse button.

18Click on OK.

19A small window opens with a message that asks if you want to add your printer to the “Printers” subpanel. Click on Yes.

20Another small window opens with a message that asks if you want to restart the workspace manager. With the left mouse button, click on OK.

21If the print spooler was not previously running, a window will open with the fol- lowing question:

Do you want to start the print spooler now?

Click on Yes.

22A window appears asking if your printer is powered on, has paper, is connected to your workstation, and is online. Check your printer to make sure it meets these requirements.

Click on OK.

32

Page 48
Image 48
HP C100/110 manual Click on Printer/Model Interface