Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

2From the rear of the storage tray, line up the disk slides on the CD-ROM or DDS tape drive with the position 1slots in the storage tray chassis, and slide it into place, as shown in Figure 26.

CD-ROM or DDS Tape Drive

Cable Routing Label

Figure 26Installing a CD-ROM or DDS Tape

3Push the storage device in until the locking tabs snap into place.

4Connect the single-ended SCSI-2 data cable and the power cable to the drive. Refer to the cable routing label on the storage tray.

5Proceed to the section entitled Replacing the Storage Tray.

126

Page 142
Image 142
HP C100/110 manual 126