Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

Storage Device Cable Routing

When you install your storage device, be aware of the suggested cable rout- ing paths as indicated in the cable routing label that is affixed to the top of the storage tray.

Disk Shield

If you are installing a hard disk manufactured by Hewlett-Packard, you need to install a disk shield.

1Check the manufacturer’s labeling on the disk drive to determine if it is a disk manufactured by Hewlett-Packard.

If the disk is not a Hewlett-Packard disk, skip the rest of this procedure.

2From the accessory hardware kit which came with your workstation, lo- cate the disk shield and four screws. See Figure 23.

3Use the four screws to mount the disk shield on the drive, as shown in Figure 23.

Figure 23

Mounting the Disk Shield

123

Page 139
Image 139
HP C100/110 manual Storage Device Cable Routing, Mounting the Disk Shield