The Boot Console Interface
Displaying and Setting the Monitor Type
Setting the Monitor Type at Power On
If you replace your workstation’s monitor with a different monitor type, and do not set the workstation’s graphics parameters by using the monitor command before doing so, you need to perform the following:
If your keyboard connects to the PS/2 connector on your system, wait 2 seconds after the Num Lock light flashes near the end of the boot sequence, then press Tab to initiate the automatic monitor selection process.
If you have a keyboard that connects to the HIL connector on your system, press Tab every three seconds during the boot sequence to initiate the automatic monitor selection process.
Your system queries you for the new monitor type. Select the new type by pressing Enter. The system queries you to confirm your selection. Press y to save this monitor type.
If you don’t press y, the system stops cycling. You can use the monitor graphics command in the configuration menu to change monitor type.
193