Woodstock ST1000 owner manual Installing Blade Guides, To install the lower blade guide

Page 14

Installing Blade
Guides
Components and Hardware Needed:	Qty
Upper Guide Assembly	1
Lower Guide Assembly	1
Blade Guard	1
Lower Guard	1
Hex Bolts M6-1 x 20	2
Hex Bolts M6-1 x 10	2
Hex Bolt M6-1 x 16	1
Fender Washers 6mm	2
Flat Washers 6mm	2
To install the lower blade guide:

1.Align and place the lower guard onto the body.

2.Align and place the lower guide assembly onto the lower guard, and insert the M6-1 x 20 hex bolts and 6mm flat washers (Figure 12).

Lower Guide

Assembly

Lower

Guard

Figure 12. Installing lower blade guide assembly.

To install the upper blade guide assembly:

1.Slide the upper guide assembly onto the guide post until the bottom of the guide post is flush with the bottom of the blade guide post hous- ing (Figure 13) and secure with an M6-1 x 16 hex bolt.

Figure 13. Installing upper blade guide.

2.Attach the blade guard to the upper guide assembly with the M6-1 x 10 hex bolts and 6mm fender washers, as shown in Figure 14.

Figure 14. Installing upper blade guard.

The blade guard MUST be installed during oper- ation. Failure to follow this warning may result in serious personal injury!

-12-	ST1000 14" Bandsaw

Image 14

Contents Manual Page Table of Contents Model ST1000 Specifications MotorMachine Features Front view of bandsawZero Risk Does Not Exist SafetySafety Instructions Safety Instructions Power Requirements OperationUnpacking SetupItems Needed for Setup QtyFence Inventory Figure Qty InventoryMain Inventory Figure Qty Hardware QtyFloor Load CleanupSite Considerations Necessary SpaceMain Body To install the main bodyAssembling Stand Components and Hardware Needed QtyMotor & Switch To install the motor and switchTo install the upper blade guide assembly Installing Blade GuidesTo install the lower blade guide To install the positive stop Installing Positive StopTo install the table Installing Fence To install the fenceTo set the positive stop Adjusting Positive StopDust Collection Changes in the blade tension may change the blade tracking Blade TrackingTo center track the blade To tension the bandsaw blade Test RunTensioning Blade Adjusting Support Bearings To adjust the support bearingsAdjusting Blade Guides To adjust the upper and lower blade guidesCalibrating Table Tilt Scale To calibrate the pointer on the table tilt scaleTo align the miter slot parallel to the bandsaw blade Aligning TableAligning Fence To align the fence parallel with the miter slotMiter Gauge To calibrate the miter gaugeOverview Operation SafetyOperations Straight CutsGuide Post Key SwitchTo adjust guide post assembly alignment on the guide post Blade Lead Table TiltTo rip with the Model ST1000 RippingCrosscutting To crosscut with the Model ST1000Resawing To resaw a workpieceTo complete a stacked cut Cutting CurvesStacked Cuts Blade Width Blade InformationBlade Length Tooth StyleBlade Breakage Tooth PitchBlade Care Most common causes of blade breakage areTo replace the blade Blade ChangesTo remove the blade Schedule MaintenanceCleaning Unpainted Cast IronMotor ServiceTroubleshooting Operation Edge of the cut WorkpieceTo check the V-belt Checking V-BeltTensioning V-Belt Tools Needed QtyReplacing V-Belt To replace the V-beltWheel Alignment To verify if the upper and lower wheels are copla- narTo Shim a Wheel 110V Motor Wiring 220V Motor Wiring ST1000 Electrical ComponentsST1000 Wiring Diagram Main Breakdown Main Breakdown Parts List DescriptionXPB73M Fence Breakdown & Parts List Safety Labels Breakdown & Parts List Warranty Warranty Registration CommentsBOX BELLINGHAM, WA