Woodstock W1673 instruction manual Mounting Motor, Quick-Connect Cord

Page 14

Figure 14. Installing pulley on motor.

Figure 15. Installing motor.

Figure 16. Plugging motor to switch.

Mounting Motor

1.Make sure the the key is in the keyway on the motor shaft. Align keyway and slide the motor pulley onto the motor shaft as far as it will go. Figure 14.

2.Align pulley with the hole in the back of the bandsaw body. Slide the motor until mounting holes align with those in top of the stand.

Figure 15.

3.Secure the motor with the (4) 516"-18 x 1" car- riage bolts, 516" hex nuts, lock washers and flat washers provided.

4.Line the motor pulley up with the lower wheel pulley and tighten the setscrew with the Allen® wrench provided.

Quick-Connect Cord

To eliminate troublesome wiring, the motor for your bandsaw has a quick-connect cord that leads from the motor to the switch. The recep- tacle end of this cord comes out of the bandsaw body near the motor and the plug end of the cord is already attached to the motor.

1.Locate the two plug ends and connect them together as shown in Figure 16.

2.Do Not become confused with the switch- to-power cord. It will not fit in the quick- connect receptacle. Do Not plug the switch- to-power cord into the power source at this time.

Do not rely on quick con- nect cord when making adjustments to bandsaw. Always unplug directly at the power source.

13

Image 14
Contents Bandsaw Table Of Contents Woodstock Service and Support Introduction About Your NEW BandsawWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions For Bandsaws Keep proper footing and balance at all timesExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Unplug saw before changing bladesUse push blocks when necessary Assembly Instructions ContentsHardware StandBandsaw Body Lifting tensioning handleMounting Motor Quick-Connect CordTo mount the table Mounting TableMounting Dust Port Rail placement Fence/RailsAdjustments Location of ControlsDiagram of speed options Speed ChangesTo remove the blade Install/Remove BladesTo install the blade To tighten your blade by sound To adjust blade tensionBlade Tension To tighten your blade by deflectionRead the next section for coplanar tracking To track the blade using center trackingTracking Wheel Alignment To check if your wheels are coplanarLower wheel adjustment control Blade Guides Blade guide assembliesTo adjust the guide blocks Guide block position on bladeTable Adjustments To square the table to the bladeTable Adjustments To make the miter gauge slot parallel with the bladeFence Adjustments To set the fence so it is parallel to the miter slotTo adjust for blade lead with the fence only option Blade LeadTest Run OperationsGeneral To perform ripping operations RippingCrosscutting To make curved cuts Cutting CurvesResawing To make stacked cuts To resaw, follow this basic procedureStacked Cuts Blade Width Blade SelectionBlade Type Blade TeethMaintenance LubricationMaintenance Schedule Maintenance NotesPage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA