Hardware, Stand | Woodstock W1673 specification

Do not connect the machine to power at this time. The machine must remain unplugged through- out the entire assembly process. Failure to do this may result in serious per- sonal injury.

Wear safety glasses dur- ing the entire assembly process. Failure to com- ply may result in serious personal injury.

Figure 11. Bandsaw stand.

Hardware

•(4) Carriage Bolts 3⁄8"-16 x 2"

•(4) Flat Washers 3⁄8"

•(5) Hex Nuts 3⁄8"-16

•(4) Carriage Bolts 5⁄16"-18 x 1"

•(4) Phillips® Head Screws 10-20 x 1⁄2"

•(6) Flat Washers 5⁄16"

•(4) Lock Washers 5⁄16"

•(4) Hex Nuts 5⁄16"-18

•(2) Hex Bolts 5⁄16"-18 x 11⁄4"

•(1) 3mm Allen® Wrench

•(1) 12mm Open End Wrench

•(1) 5mm Allen® Wrench

•(1) Setscrew 1⁄4"-20 x 1⁄4"

•(1) Hex Bolt 3⁄8"-16 x 21⁄2"

•(1) Knob 5⁄16"-18 x 1" (stand)

•(1) Lock Nut 5⁄16"-18 (stand)

•(1) Knob 3⁄8"-16 x 1" (table)

•(1) Pin 3 x 10 (table)

•(4) Cap Screws M6-1 x 30 (fence)

•(1) Knob 3⁄8"-16 x 3⁄4" (fence)

•(4) Spacer Sleeves (fence)

While the main components of the Shop Fox® W1673 16" Bandsaw are assembled at the facto- ry, some assembly is required. The following is the recommended sequence best suited for final assembly.

Stand

The W1673 Bandsaw stand (Figure 11) should be placed on a hard, flat floor. There should be enough area surrounding the bandsaw to allow proper working clearances. Make sure to place the stand so the cabinet door is in front.

With the door open, insert the 5⁄16"-18 x 1" knob into the door of the stand. Thread the 5⁄16" lock nut onto the knob. Leave enough play so you can still rotate the knob to tighten/untighten the door to the stand body.