To resaw, follow this basic procedure:
1.Ensure that your bandsaw is properly setup according to the Adjustments section in this manual.
2.Use the widest blade that will fit your saw (1"). Also, make sure your blade is sharp and in good condition.
3.Before cutting your workpiece, it is a good idea to test cut a piece of scrap lumber to make sure your bandsaw is set up properly for the job. It is better to make any mis- takes on scrap, than to accidentally ruin an expensive piece of lumber.
4.Whether cutting the scrap or the actual workpiece, feed the wood slowly and even- ly into the blade. Do not force it!
Note: If the blade wanders when using the fence, adjust the fence as stated in the “Blade Lead” section on page 28.
Always wear safety glass- es when operating the bandsaw. Failure to com- ply may result in serious personal injury.
Figure 54. Making a stacked cut.
Stacked Cuts
Another useful operation for the bandsaw is making stacked cuts. See Figure 54. These cuts provide uniformity to multiple pieces.
To make stacked cuts:
1.Line up and secure the multiple pieces together. Screws or brads in the waste por- tion work well for this. Make sure that your blade is absolutely square to the table.
2.Trace the pattern on the top piece. Make relief cuts through the waste portion where the blade will change directions.
3.Cut the stack as though you were cutting a single piece.
Do not cut into the nails or screws that you are using to fasten stacked pieces. This may send dangerous debris into the air and will ruin your blade.
32