Woodstock W1673 instruction manual Box Bellingham, Wa

Page 45

FOLD ALONG DOTTED LINE

Place

Stamp

Here

WOODSTOCK INTERNATIONAL, INC.

P.O. BOX 2309

BELLINGHAM, WA 98227-2309

FOLD ALONG DOTTED LINE

TAPE ALONG EDGES--PLEASE DO NOT STAPLE

Image 45
Contents Bandsaw Table Of Contents Introduction About Your NEW Bandsaw Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Additional Safety Instructions For Bandsaws110V Operation Electrical RequirementsExtension Cords Grounding220V Operation Unplug saw before changing blades Avoiding Potential InjuriesUse push blocks when necessary Contents Assembly InstructionsStand HardwareLifting tensioning handle Bandsaw BodyQuick-Connect Cord Mounting MotorMounting Table Mounting Dust PortTo mount the table Fence/Rails Rail placementLocation of Controls AdjustmentsSpeed Changes Diagram of speed optionsInstall/Remove Blades To install the bladeTo remove the blade Blade Tension To adjust blade tensionTo tighten your blade by sound To tighten your blade by deflectionTo track the blade using center tracking TrackingRead the next section for coplanar tracking To check if your wheels are coplanar Wheel AlignmentLower wheel adjustment control Blade guide assemblies Blade GuidesGuide block position on blade To adjust the guide blocksTo square the table to the blade Table AdjustmentsTo make the miter gauge slot parallel with the blade Table AdjustmentsTo set the fence so it is parallel to the miter slot Fence AdjustmentsBlade Lead To adjust for blade lead with the fence only optionOperations GeneralTest Run Ripping CrosscuttingTo perform ripping operations Cutting Curves ResawingTo make curved cuts To resaw, follow this basic procedure Stacked CutsTo make stacked cuts Blade Type Blade SelectionBlade Width Blade TeethLubrication MaintenanceMaintenance Notes Maintenance SchedulePage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA