Woodstock W1673 instruction manual To adjust the guide blocks, Guide block position on blade

Page 25

Blade Guides Cont.

The upper and lower guide blocks reduce side-to- side blade wander during cutting. Proper adjust- ment of these will also minimize heat and increase blade life.

To adjust the guide blocks:

1.Find the thumbscrews that allow the guide- block pair to slide back and forth.

2.Set the guide blocks just behind the gullet of the teeth. See Figure 39. This will protect your blade from premature wear because the teeth won’t run against the guide blocks.

3.Now find the thumbscrews that allow each guide block to slide in and out.

4.The ideal distance that the guide blocks should be set from the blade is .004 in. Again, if you have a feeler gauge use it; oth- erwise, the single thickness of a dollar will be fairly accurate. Fold the dollar once and slide the open end over the blade, so the dollar covers each side of the blade. See

Figure 40.

5.Pinch the dollar between the blade and a guide block on one side, making sure you don’t move the blade.

6.Lock the guide block into place and repeat Step 5 on the other side. Use this same process for adjusting the lower guide blocks as well.

Figure 39. Guide block position on blade.

Figure 40. Guide block position on blade.

24

Image 25
Contents Bandsaw Table Of Contents Introduction About Your NEW Bandsaw Woodstock Service and SupportMachine Specifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Safety FirstKeep proper footing and balance at all times Additional Safety Instructions For Bandsaws110V Operation Electrical RequirementsExtension Cords Grounding220V Operation Unplug saw before changing blades Avoiding Potential InjuriesUse push blocks when necessary Contents Assembly InstructionsStand HardwareLifting tensioning handle Bandsaw BodyQuick-Connect Cord Mounting MotorMounting Dust Port Mounting TableTo mount the table Fence/Rails Rail placementLocation of Controls AdjustmentsSpeed Changes Diagram of speed optionsTo install the blade Install/Remove BladesTo remove the blade Blade Tension To adjust blade tensionTo tighten your blade by sound To tighten your blade by deflectionTracking To track the blade using center trackingRead the next section for coplanar tracking To check if your wheels are coplanar Wheel AlignmentLower wheel adjustment control Blade guide assemblies Blade GuidesGuide block position on blade To adjust the guide blocksTo square the table to the blade Table AdjustmentsTo make the miter gauge slot parallel with the blade Table AdjustmentsTo set the fence so it is parallel to the miter slot Fence AdjustmentsBlade Lead To adjust for blade lead with the fence only optionGeneral OperationsTest Run Crosscutting RippingTo perform ripping operations Resawing Cutting CurvesTo make curved cuts Stacked Cuts To resaw, follow this basic procedureTo make stacked cuts Blade Type Blade SelectionBlade Width Blade TeethLubrication MaintenanceMaintenance Notes Maintenance SchedulePage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA