Woodstock W1673 instruction manual Maintenance Schedule, Maintenance Notes

Page 36

Maintenance Schedule

•Every 2 Hours of Running Time: Clean and lubricate table top, miter slot and fence.

•Every 3 Hours of Running Time: Check blade tracking, guide column and table-to-blade. Check gap on guide blocks and thrust bearings. Check blade tension.

• Every 5

Hours of Running Time:

Oil guide post with light machine oil.

• Every 6-8 Hours of Running Time:

Replace blades.

• Every Year:

Replace the rubber V-Belt (recommended).

• Every 2

Years:

Replace the rubber tires on the wheels (recommended).

Maintenance Notes

DATE

MAINTENANCE PERFORMED

35

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Bandsaw Table Of Contents Woodstock Service and Support Introduction About Your NEW BandsawWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions For Bandsaws Keep proper footing and balance at all timesElectrical Requirements 110V OperationExtension Cords Grounding220V Operation Avoiding Potential Injuries Unplug saw before changing bladesUse push blocks when necessary Assembly Instructions ContentsHardware StandBandsaw Body Lifting tensioning handleMounting Motor Quick-Connect CordMounting Table Mounting Dust PortTo mount the table Rail placement Fence/RailsAdjustments Location of ControlsDiagram of speed options Speed ChangesInstall/Remove Blades To install the bladeTo remove the blade To adjust blade tension Blade TensionTo tighten your blade by sound To tighten your blade by deflectionTo track the blade using center tracking TrackingRead the next section for coplanar tracking Wheel Alignment To check if your wheels are coplanarLower wheel adjustment control Blade Guides Blade guide assembliesTo adjust the guide blocks Guide block position on bladeTable Adjustments To square the table to the bladeTable Adjustments To make the miter gauge slot parallel with the bladeFence Adjustments To set the fence so it is parallel to the miter slotTo adjust for blade lead with the fence only option Blade LeadOperations GeneralTest Run Ripping CrosscuttingTo perform ripping operations Cutting Curves ResawingTo make curved cuts To resaw, follow this basic procedure Stacked CutsTo make stacked cuts Blade Selection Blade TypeBlade Width Blade TeethMaintenance LubricationMaintenance Schedule Maintenance NotesPage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA
Top Page Image Contents