Woodstock W1673 instruction manual Mounting Table, Mounting Dust Port, To mount the table

Mounting Table

The table is secured to the bandsaw by two trunnions mounted to its bottom surface. These, in turn, have threaded studs that work to lock the table’s angle with respect to the blade. In order to mount the table, you must first mount the trunnion support.

Secure the trunnion support with the (2) 5⁄16"-18 x 11⁄4" hex bolts and 5⁄16" flat washers as shown in

Figure 17.

Next, partially insert the positive stop bolt (Hex Bolt 3⁄8"-16 x 21⁄2") with a 3⁄8" hex nut threaded halfway up the length. The location for the pos- itive stop bolt is shown in Figure 17.

To mount the table:

1.You should have removed the bandsaw blade as stated in step 2 of the “Bandsaw Body” assembly instructions. If you haven’t done this, do it now.

2.Rotate table until the table pin points away from the bandsaw body.

3.Look under table and align threaded studs with holes in the table support. Allow table to rest on the trunnions, making sure the studs go through the support.

4.Secure table as shown in Figure 18 with the two hand knobs provided.

Positive

Stop Goes

Here

Figure 17. Attaching trunnion support to body.

Figure 18. Securing table with the hand knobs.

Mounting Dust Port

There is a vent in the body of the bandsaw directly under the table. Attach the dust port over this vent with the (4) 10-24 x 1⁄2" Phillips® head screws as shown in Figure 19.

Figure 19. Installing dust port.

14