Woodstock W1673 instruction manual Use push blocks when necessary

Page 10

AVOIDING POTENTIAL INJURIES

Figure 7. Use push blocks when necessary.

Figure 8. Never place hands in line of cut.

Figure 9. Use relief cuts for tight curves.

9

Image 10

Contents Bandsaw Table Of Contents Woodstock Service and Support Introduction About Your NEW BandsawWarranty and Returns Machine SpecificationsSafety First Disconnect machine when cleaning, adjusting or servicingAdditional Safety Instructions For Bandsaws Keep proper footing and balance at all timesExtension Cords Electrical Requirements110V Operation Grounding220V Operation Avoiding Potential Injuries Unplug saw before changing bladesUse push blocks when necessary Assembly Instructions ContentsHardware StandBandsaw Body Lifting tensioning handleMounting Motor Quick-Connect CordMounting Dust Port Mounting TableTo mount the table Rail placement Fence/RailsAdjustments Location of ControlsDiagram of speed options Speed ChangesTo install the blade Install/Remove BladesTo remove the blade To tighten your blade by sound To adjust blade tensionBlade Tension To tighten your blade by deflectionTracking To track the blade using center trackingRead the next section for coplanar tracking Wheel Alignment To check if your wheels are coplanarLower wheel adjustment control Blade Guides Blade guide assembliesTo adjust the guide blocks Guide block position on bladeTable Adjustments To square the table to the bladeTable Adjustments To make the miter gauge slot parallel with the bladeFence Adjustments To set the fence so it is parallel to the miter slotTo adjust for blade lead with the fence only option Blade LeadGeneral OperationsTest Run Crosscutting RippingTo perform ripping operations Resawing Cutting CurvesTo make curved cuts Stacked Cuts To resaw, follow this basic procedureTo make stacked cuts Blade Width Blade SelectionBlade Type Blade TeethMaintenance LubricationMaintenance Schedule Maintenance NotesPage Closure Page Page Page XPB03 Adapter Warranty Card BOX BELLINGHAM, WA