Delta DLKC6580V2-1 Maintenance, To Check Safety Valve, Customer Responsibilities

MAINTENANCE

Customer Responsibilities

	Before	Every	Every	Every	Every	Every
	each	8	40	100	160	500	Yearly
	use	hours	hours	hours	hours	hours
Check Safety Valve	●
Drain Tank		●
Check Oil		●
Change Oil				●2		●2
Unusual Noise and/or		●
Vibration
Air Filter			●1
Drive Belt-Condition			●
Motor Pulley/Flywheel alignment					●
Air compressor pump intake							●
and exhaust valves
Inspect air lines and fittings	●
for leaks

Head Bolts - Check the torques of the head bolts after the first five hours of operation.

1- more frequent in dusty or humid conditions

2- more frequent if humidity or operating conditions are extreme.

Unit cycles automatically when power is on. When per- forming maintenance, you may be exposed to voltage

sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure.

To ensure efficient operation and longer life of the air compressor outfit, a rou- tine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working envi- ronment operating on a daily basis. If necessary, the schedule should be modi- fied to suit the conditions under which your compressor is used. The modifica- tions will depend upon the hours of operation and the working environment. Compressor outfits in an extremely dirty and/or hostile environment will require a greater frequency of all maintenance checks.

NOTE: See “Operation” section for the location of controls.

To Check Safety Valve

If the safety valve does not work prop-

erly, over-pressurization may occur, causing air tank rupture or an explosion.

1.Before starting compressor, pull the ring on the safety valve to make sure that the safety valve operates freely. If the valve is stuck or does not operate smoothly, it must be replaced with the same type of valve.

D26161 16-ENG