Emerson CMF200A installation manual Mounting the temperature extender onto the sensor

Page 15

Mounting the Sensor

Figure 10 Mounting the temperature extender onto the sensor

Clamping ring screw — when extender is engaged, tighten this to 13–18 in-lbs (1.5–2 N-m)

Feedthrough — note the notches for correct engagement of the extender

Model 2400S transmitter or enhanced core processor — preinstalled on the extended mount

Extended mount — carefully align the notches at the bottom of the extended mount with the notches on the feedthrough to engage properly

Plastic plug — remove and discard

Mounting the electronics of high-temperature and extreme high-temperature sensors

High-temperature and extreme high-temperature ELITE sensors come with a 32″ (812 mm) pre-installed flexible conduit. This conduit is required for agency approval.

A factory-supplied Model 2400S transmitter, Model 1700/2700 transmitter, core processor, or junction box is connected to the end of the flexible conduit. Mount the electronics to a wall or instrument pole using the supplied bracket (Figure 11).

Installation Manual

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Micro Motion Elite Sensors Page Customer service TroubleshootingBefore You Begin Specifications Definitions European installationsInstallation options CMF025, CMF050, or CMF100 Elite sensor with core processor Elite sensor with junction box Environmental limits Hazardous area installationsDetermining a Location Full flow tubes113 Sensor models Electronics UL and CSA ambient temperature limitsValves Maximum wiring distancesMaximum cable lengths Pipe runVertical pipeline Orienting the SensorRecommended sensor orientations Flow direction arrowMounting an Elite sensor Mounting the SensorFeedthrough, plastic cap, and clamping ring Installing extended mount electronicsMounting the temperature extender onto the sensor Installing wafer-style sensors Wafer-style assembly Core processor to a 4-wire remote transmitter WiringWrapping the shield drain wires Applying the heat shrink Connecting the wires at the core processor Grounding Pressure RatingsElite pressure ratings Case purging procedure Purge FittingsRemoving a purge plug Time required to purge Elite sensor cases Rupture DisksReturn Policy New and unused equipmentUsed equipment 20002158
Top Page Image Contents