Sears manual Supplied WiTH Model 113.243311 only, Thread, Motor Connections, Strain Relief

CRAFTSMAN 12-iNCH BAND SAW/SANDER, MODEL 113.243300 & 113.243311

NOTE:

ANY ATTEMPT TO REPAIR THIS MOTOR

MAY CREATE A HAZARD UNLESS REPAIR IS DONE BY QUALIFIED

SERVICE TECHNICIAN.

REPAIR SERVICE IS AVAILABLE

AT YOUR NEAREST SEARS STORE.

3

\

\

\

@-

FIGURE 4-- MOTOR PART NO. 69183

SUPPLIED WiTH MODEL 113.243311 ONLY

Key	Part
No.	No.			Description
	60306	Screw,	8-32 x 3/8,		Thread
		Cutting,		Slotted,	Serrated
		Hd.
	64088	Cover,	Terminal
	64258	Cord	with	Plug

TERMINAL

MOTOR CONNECTIONS

WARNING: FOR YOUR OWN SAFETY, NEVER

CONNECT PLUG TO POWER SOURCE OUTLET UNTIL

ALL ASSEMBLY STEPS ARE COMPLETED.

1.Open motor connector box cover located on left end of motor (viewed from rear of saw) using a flat blade screwdriver.

2.Remove GREEN SCREW and Iockwasher and insert

screw through round metal terminal on the end of the

GREEN wire of power cord with tockwasher between terminal and motor frame. (See illus.)

3.Reinsert GREEN SCREW in the threaded hole. Tighten securely.

GREEN

iNTERNAL'

LOCKWASHER

GREEN WIRE -TOGREEN SCREW

4.

Insert

terminal

end

of WHITE

wire

on spade

terminal

marked

T4

on

the

motor.

Push

terminal

firmly

until

STRAIN RELIEF

seated.

pOVE

5.

Insert

terminal

end

of BLACK

wire

on spade

terminal

TO

marked

T1

on

the

motor.

Push

terminal

firmly

until

TERMINAL T4

seated.

6.Close motor connector box being sure that power cord is seated in the largest strain relief groove, and tighten box cover screws.

29