FUNCTIONAL DESCRIPTION
TOOL ASSEMBLY
| 1 |
|
| 3 | 4 |
|
|
|
| ||
| 16 |
|
|
|
|
15 |
|
|
| 2 |
|
14 |
|
|
|
|
|
|
|
|
|
| 5 |
|
|
|
|
| 6 |
13 |
|
|
|
|
|
12 |
|
|
|
| 7 |
|
|
| 8 |
| |
|
|
|
|
| |
|
|
|
| 9 |
|
|
| 11 | 10 |
| |
|
|
|
| ||
|
| 12. | Sight line |
| |
1. | 13. | Rip fence slot |
| ||
2. | Trigger | 14. | Rip fence adjusting knob |
| |
3. | Handle | 15. | Upper guard |
| |
4. | Battery | 16. | Front handle |
| |
5. | Battery pack release buttons | 17. | Depth setting gauge |
| |
6. | Shoe | 18. | Wrench |
| |
7. | Lower guard lever | 19. | Spindle lock button |
| |
8. | Lower guard | 20. | Depth adjusting lever |
| |
9. | Blade bolt | 21. | Bevel adjusting knob |
| |
10. | Blade flange | 22. | Bevel pointer |
| |
11. | Blade | 23. | Bevel scale |
| |
21 |
| 17 |
| 18 |
|
22 |
|
|
|
|
|
|
|
|
|
| 19 |
23 |
|
|
|
|
|
|
| 20 |
|
|
|
WARNING
Recharge only with the charger specified for the battery pack. For specific charging instructions, read the operator's manual supplied with your charger and battery pack.
WARNING
To reduce the risk of injury, always remove battery pack before attaching or removing accessories. Use only specifically recommended accesso- ries. Others may be hazardous.
Removing Battery Pack from Tool
Push in the release buttons and slide the battery pack away from the tool.
Inserting Battery Pack into Tool
To insert the battery pack into the tool, push in the release buttons and slide it into the body of the tool.
Fig. 1 |
Removing a |
battery pack |
Inserting a |
battery pack |
Selecting Blade
Always use sharp blades. Dull blades tend to overload the tool and increase the chance of KICKBACK (see "Causes and Operator Prevention of KICKBACK"). Only use thin kerf blades with a maximum safe operating speed greater than the no load RPM marked on the tool's nameplate. Read the blade manufacturer's instructions before use. Do not use any type of abrasive
Installing and Removing Blades
1.REMOVE BATTERY PACK BEFORE IN- STALLING OR REMOVING BLADES.
2.Place the saw on a flat surface with the blade facing upwards. To remove the bolt from the spindle, push in the spindle lock button. While holding the spindle lock button in, use the wrench provided with the tool to turn the bolt clockwise (Fig. 2). Remove the bolt and blade flange.
Fig. 2
3.Slide the lower guard lever up to raise the lower guard. Remove the blade from the spindle. Always clean the spindle, upper guard and lower guard to remove any dirt and sawdust.
NOTE: Do not remove inner blade flange. Larger diameter of inner flange (Fig. 3) should face the blade.
Fig. 3 Spindle | Bolt |
Inner flange | Outer flange |
6 |
7