1. Beginning at a corner, line up the sight |
MAINTENANCE
Fig. 14
WARNING
line with your cutting line. Tilt the saw |
forward, firmly fixing the front of the shoe |
on the workpiece. The blade should be |
just above cutting line, but not touching |
it. Raise the lower guard using the lower |
guard lever. |
2. To start the saw, push the |
down while pulling the trigger. Allow the |
motor to reach full speed before begin- |
ning cut. Using the front of the shoe as |
a hinge point, gradually lower the back |
end of the saw into the workpiece. Re- |
lease the lower guard lever and grasp |
the front handle. |
3. When the shoe rests flat against work- |
piece, advance the saw to the far corner. |
Release the trigger and allow the blade |
to come to a complete stop before re- |
moving it from workpiece. Repeat the |
above steps for each side of the open- |
ing. Use a Sawzall® reciprocating saw, |
jig saw or small hand saw to finish the |
corners if they are not completely cut |
through. |
WARNING
To reduce the risk of personal in- jury, always unplug the charger and remove the battery pack from the charger or tool before performing any maintenance. Never disassemble the tool, battery pack or charger. Contact a MILWAUKEE service facility for ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good repair by adopting a regular main- tenance program. After six months to one year, depending on use, return the tool, battery pack and charger to a MILWAUKEE service facility for:
•Lubrication
•Brush inspection and replacement
Cleaning
Clean out dust and debris from vents and electrical contacts by blowing with com- pressed air. Keep tool handles clean, dry and free of oil or grease. Use only mild soap and a damp cloth to clean the tool, battery pack and charger, keeping away from all electri- cal contacts. Certain cleaning agents and solvents are harmful to plastics and other insulated parts. Some of these include gaso- line, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia and household detergents containing ammonia. Never use flammable or combustible sol- vents around tools.
Repairs
For repairs, return the tool, battery pack and charger to the nearest authorized service center.
To reduce the risk of electric shock, check work area for hidden pipes and wires before making pocket cuts.
Pocket Cutting
Pocket cuts are made in the middle of the workpiece when it can not be cut from an edge. We recommend using a Sawzall® reciprocating saw or jig saw for this type of cut. However, if you must use a circular saw to make a pocket cut, USE EXTREME CAUTION. To maintain control of the saw during pocket cutting, keep both hands on the saw (Fig. 15).
Fig. 15
•Mechanical inspection and cleaning (gears, spindles, bearings, housing, etc.)
•Electrical inspection (battery pack, charger, motor)
•Testing to assure proper mechanical and electrical operation
If the tool does not start or operate at full power with a fully charged battery pack, clean the contacts on the battery pack. If the tool still does not work properly, return the tool, charger and battery pack to a MILWAUKEE service facility for repairs.
WARNING
To reduce the risk of personal in- jury and damage, never immerse your tool, battery pack or charger in liquid or allow a liquid to flow inside them.
ACCESSORIES
WARNING
Always remove battery pack before changing or removing accessories. Only use accessories specifically recommended for this tool. Others may be hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog or go
Thin Kerf Blades
Special thin kerf blade designed for cordless circular saws.
24 Tooth Blade (Cat. No.
40 Tooth Blade (Cat. No.
Blade Wrench (Allen)
Cat. No.
Blade Wrench
Cat. No.
Rip Fence
Cat. No.
12 | 13 |