Husqvarna TS 355 With Machine Cold and Setting Level, Hour Operation Check List, Service Daily

Page 15

PRE OPERATION CHECKLIST

Before leaving our factory, every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions.

Before starting up the machine, make sure you read this entire Operation’s Manual and are fa-

miliar

with the operation of the machine.

WITH MACHINE COLD AND SETTING LEVEL:

1.Gasoline Models: Check engine oil. Fill to the full mark on dip stick with 10W30 oil, class MS, SD, SE or better.

2.Electric Models: Verify all electrical connections are intact.

1 - 2 HOUR OPERATION CHECK LIST:

ALWAYS place the machine on a level surface with the engine/motor “OFF", the ignition switch set in the “OFF” position and disconnected from the power source before performing any maintenance. Let the machine cool down!!

1.Check the engine air cleaner hose clamps. Tighten as required.

2.Tension the blade drive V-belts. DO NOT over tension!!

SCHEDULED MAINTENANCE QUICK REFERENCE:

Before performing any maintenance, ALWAYS place the machine on a level surface with the engine/motor “OFF” and the ignition switch set in the “OFF” position.

SERVICE DAILY:

1.Check engine oil level.

2.Check blade guard for damage.

3. Check hoses and clamps for damage . or looseness. Tighten or replace as necessary.

4.Check air cleaner. Clean or replace as required.

5.Clean the reservoir pan frequently.

6.At the end of each day, flush clean water through the water pump and hoses

SERVICE EVERY 50 HOURS:

1.Replace engine oil and filter.

2.Clean engine air fins.

3.Check blade drive V-belt tension.. DO NOT over tension!!!

4.Clean engine fuel bowl.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents TS 355 G Esta máquina hayan leído este manual Symbol Definitions Definición DE Simbolos Page Page Hearing Hazard Riesgo DE Daño AuditivoCalifornia Prop 65 Warning 542 19 Location Front of Pan, Belt Guard, All Models Qty Power Source SpecificationsSAW Dimensions Follow all electrical codes in your area Do use caution when handling fuelBlade Do only cut in a straight lineDo not Figures Page Parts Identification Hour Operation Check List With Machine Cold and Setting LevelService Daily Service Every 50 HoursFeatures AssemblyIndication Mandatory Information Instruction Electric Models FIG Extension Cord Size A.W.G. MinimumGasoline Model Fig Check Before Operating Fitting The Blade FigureOperating Instructions Cutting Operations Incidents During Operation MaintenanceImportant Advice Belt TensionAll Models Figs Reference Information AccessoriesRepairs Spare PartsNota Especificaciones Modelo no Dimensiones DE LA Sierra Advertencias Advertencias FigurAS Page Identificación de Piezas CON LA Maquina Fria Y Nivelada Mantenimiento DiarioMantenimiento Cada 50 Horas Armado CaracteristicasNema No Enchutes y Connectores del Motor Electrico ConectorMotor Requenido Del MotorSolamente Modelos Eléctricos Verifique Antes De OperarColocación De La Hoja Ver la Ilustracion Todos los ModelosAdvertencia Use solamente hojas abrasivas del tipo reforzado Instrucciones De OperaciónIncidentes Durante La Operación Alineación de la Hoja Ilustraciones 11 y MantenimientoVerifique Diariamente Todos los Modelos Procedimiento para el Cambio de Aceite del MotorConsejo Importante Tensión de la Cinta enNotas ReparacionesPiezas De Repuesto AccesoriosPage Page Wiring Diagram 3 HP Electric Motor Wiring Diagram 5.5 HP Honda Nota Nota Nota International Corporate OfficeSouth Carolina Canada542 20
Top Page Image Contents