RIDGID WL1200LS1 manual Mounting Rear Foot, Pan Head Screw, Nut Square Flat Washer

Mounting Rear Foot

1. Locate the following:
1	M8 x 1.25-45 Pan Head Screw	Carriage Bolt
1	M8 x 1.25 Square Nut
		M6 x 1.0-65
1	M6 x 1.0-65 Carriage Bolt
1	6.5 x 19 x 1.6 Flat Washer
1	6mm Lockwasher	Pan Head Screw
1	M6 x 1.0 Hex Nut
		M8 x 1.25-45
		Lockwasher
	Nut Square	Flat Washer	6mm
	M8 x 1.25	6.5 x 19 x 1.6

Nut Hex

M6 x 1.0

2.Install the rear foot onto the tube as shown and tighten rear foot locking screw. One corner of the nut will rest in the trough on the foot, the opposite cor- ner of the nut will rest against the wall of the tube. Foot will wedge into place as screw is tightened. This may take several attempts.

3.Attach the rear foot on the right side table board, hole labeled K. Secure in place with bolt, washer, lockwasher and nut as shown.

Pan Head Screw

Carriage Bolt M8 x 1.25-45

M6 x 1.0-65

Rear Foot

Square

Headstock Nut

End

Hole K

Washer

Lockwasher

Tube Hex Nut

Assembly

19