Woodstock W1752 owner manual Safety

Page 11

W1752 Owner's Manual (Mfg. 1/07+)

13.FACEPLATE TURNING. When faceplate turning, use lathe chisels on the downward spinning side of the workpiece only.

14.SANDING/POLISHING. Remove the tool rest when performing sanding or polishing operations on the rotating spindle.

15.MATERIAL REMOVAL RATE. Removing too much material at once may cause workpiece to fly out of the lathe.

16.REDUCING WORKPIECE VIBRATION. If the workpiece vibrates, immediately turn the lathe OFF. Check to make sure the workpiece is centered and balanced. Trim excess waste off corners with a bandsaw or table saw to reduce vibration. Make sure workpiece is securely attached in setup.

SAFETY

-9-

Image 11

Contents OWNERS MANUAL Page Contents Woodstock Technical Support IntroductionElectrical Overall DimensionsMotor Other Specifications Main SpecificationsControls and Features Standard Safety Instructions SafetyAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Safety Extension Cords Electrical SpecificationsElectrical 110V OperationBox Inventory Figure SET UPUnpacking InventoryMachine Placement Cleaning Machine To install the tool rest, do these steps AssemblyTo test run the mini wood lathe, do these steps Test RunGeneral OperationsTo position the tailstock along the bed, do these steps Adjusting TailstockChanging Speeds To change speeds, do these stepsTo install the spur center, do these steps Adjusting Tool RestInstalling/Removing Spur Center To adjust the tool rest vertically, do these stepsTo remove the live center, do these steps Installing/Removing Live CenterTo install the live center, do these steps To mount a workpiece to your faceplate, refer to Installing/Removing FaceplateTo install the faceplate, do these steps Gouge Selecting Turning ToolsSpindle Turning To set up a spindle turning operation, do these stepsSpindle Turning Tips To mount your workpiece to a backing block, do these steps Faceplate TurningTo mount your workpiece to the faceplate, do these steps Entanglement Hazard Sanding/FinishingLathe Accessories AccessoriesUnpainted Cast Iron MaintenanceCleaning LubricationTroubleshooting ServiceConstant Paddle Switch Wiring Diagram W1752Parts REF PART # Description Parts ListPART # Description Label PlacementPage Page Page Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools