W1752 Owner's Manual (Mfg. 1/07+)
Assembly
To install the tool rest, do these steps:
1.Turn the release lever on the tool rest base so it does not interfere with assembly.
2.Thread the tool rest lock handles into the tool rest base (Figure 4) until the threaded ends of the handles are flush with the inside of the shaft.
3.Insert the tool rest into the shaft and turn the handles to lock it as shown in Figure 5.
4.Install the optional bed extension, Model W1753 (Page 25). Refer to the instruction sheet included with the bed extension.
Lock |
Handles |
Release |
Lever |
Tool Rest |
Base |
Figure 4. Tool rest lock handles installed.
SET UP