W1752 Owner's Manual (Mfg. 1/07+)
Test Run
SET UP
Complete this process once you have familiarized yourself with all instructions in this manual.
The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety paddle switch works correctly.
To test run the mini wood lathe, do these steps:
1.Read the entire instruction manual first!
2.Make sure all tools and foreign objects have been removed from the machine.
3.Review Page 10 and connect your machine to the power source.
4.Flip the paddle switch up to turn the machine ON. Make sure that your hand stays poised over the switch in case you need to quickly turn the machine
OFF.
—If you suspect any problems, immediately turn the lathe OFF and disconnect the machine from the power, and refer to Page 27 to troubleshoot/fix any problems before starting the lathe again.
—If the source of an unusual noise or vibration is not readily apparent, contact our technical sup- port for help at (360)
5.Turn the machine OFF.
6.Remove the safety key and attempt to turn the machine ON.
—If the machine starts, stop it. The switch disabling feature is not working. This safety feature must work properly before proceeding. Contact our technical support for help.
—If the machine does not start, the switch disabling feature is working.
Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses during assembly and operation.
Loose hair and clothing could get caught in machinery and cause serious personal injury. Keep loose clothing rolled up and long hair tied up and away from machinery.