Nikon S1100pj user manual Troubleshooting, Display, Settings and Power Supply, 186

Troubleshooting

If the camera fails to function as expected, check the list of common problems below before consulting your retailer or Nikon-authorized service representative.

Display, Settings and Power Supply

	Problem		Cause/Solution	A
		•	Camera is off.	21
		•	Battery is exhausted.	26
		• Standby mode for saving power: press the		21, 153
			power switch, the shutter-release button, A
			button, c button, or b (movie-record)
			button.
		• When flash lamp blinks, wait until flash has		35
	Monitor is blank.		charged.
		• Camera and computer are connected via USB		132
			cable.
		• Camera and TV are connected via audio/video		129
			cable.
		• The monitor turns off when using the remote		163
			control to operate the camera in projector
			mode.
	Monitor is hard to read.	•	Adjust monitor brightness.	148
		• Monitor is dirty. Clean monitor.		177
		•	Battery is exhausted.	26
		• Camera has turned off automatically to save		153
		•	power.
	Camera turns off without		The camera has become hot due to the heat	164,
Technical	warning.		of the projector. Leave the camera off until it	181
			has cooled and then turn it on again.
		• The camera and battery may not work		176
Notes			properly at low temperatures.
		•	If camera clock has not been set, “Date not	22, 145
and			set” indicator blinks during shooting and
			movie recording. Pictures and movies
Index
	Date and time of recording are		recorded before clock is set are dated “00/00/
			0000 00:00” or “01/01/2010 00:00”
	not correct.
			respectively. Set the correct time and date
			from the Date option in the setup menu.
		• Check camera clock regularly against more		145
			accurate timepieces and reset as required.
	No indicators displayed in	Playback is set to Auto info for Monitor		148
	monitor.	settings in the setup menu.
	Date imprint not available.	Date setting is not applied in the setup menu.		22, 145

186