Woodstock W1752 Installing/Removing Live Center, To install the live center, do these steps

Page 20

W1752 Owner's Manual (Mfg. 1/07+)

OPERATIONS

To remove the spur center with the knock-out bar, do these steps:

1.Unplug lathe from power!

2.Hold a clean rag under the spindle or wear a glove to catch the center when you remove it.

3.Insert the knock-out bar through the outboard end of the spindle and tap the center (as shown in Figure 11). Catch the center as it falls out.

Installing/Removing

Live Center

To install the live center, do these steps:

1.Loosen the quill lock handle (if locked) approximate- ly half a turn counterclockwise.

2.Rotate the quill handwheel clockwise until the tailstock quill protrudes out of the tailstock housing about 3/4''.

3.Insert the live center, as shown in Figure 12, and push firmly.

4.Tighten the lock handle.

Figure 11. Removing spur center using

knock out bar.

Quill Lock Handle

Quill

Quill Handwheel

To remove the live center, do these steps:

1.Turn the quill handwheel counterclockwise until the tailstock quill bottoms out, causing the center to be forced out of the quill.

Figure 12. Installing live center.

The tailstock quill lock handle must always be locked down while the lathe is in use. The workpiece can be thrown from the lathe if this step is not observed. Also, the tailstock quill should not protrude from the tailstock housing more than 2'' or the quill will not be supported enough. Failure to follow these warnings may result in personal injury.

-18-

Image 20

Contents OWNERS MANUAL Page Contents Introduction Woodstock Technical SupportElectrical Overall DimensionsMotor Main Specifications Other SpecificationsControls and Features Safety Standard Safety InstructionsAlways Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Safety Electrical Specifications Electrical110V Operation Extension CordsSET UP UnpackingInventory Box Inventory FigureMachine Placement Cleaning Machine Assembly To install the tool rest, do these stepsTest Run To test run the mini wood lathe, do these stepsOperations GeneralAdjusting Tailstock Changing SpeedsTo change speeds, do these steps To position the tailstock along the bed, do these stepsAdjusting Tool Rest Installing/Removing Spur CenterTo adjust the tool rest vertically, do these steps To install the spur center, do these stepsTo remove the live center, do these steps Installing/Removing Live CenterTo install the live center, do these steps To mount a workpiece to your faceplate, refer to Installing/Removing FaceplateTo install the faceplate, do these steps Selecting Turning Tools GougeTo set up a spindle turning operation, do these steps Spindle TurningSpindle Turning Tips To mount your workpiece to a backing block, do these steps Faceplate TurningTo mount your workpiece to the faceplate, do these steps Sanding/Finishing Entanglement HazardAccessories Lathe AccessoriesMaintenance CleaningLubrication Unpainted Cast IronService TroubleshootingConstant Wiring Diagram W1752 Paddle SwitchParts Parts List REF PART # DescriptionLabel Placement PART # DescriptionPage Page Page Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools