Black & Decker BDBS100 Operating Controls and Adjustments, Starting Stopping SAW

OPERATING CONTROLS AND ADJUSTMENTS

WARNING: THIS PRODUCT IS RECOMMENDED FOR WOOD CUTTING ONLY.

STARTING AND

STOPPING SAW

The switch (A) Fig. 15, is located on the front side of the band saw. To turn the saw “ON” move the switch

(A)up to the “ON” position. To turn the saw “OFF” move the switch (A) down to the “OFF” position.

A

Fig. 15

LOCKING SWITCH IN

THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use. This can be done by grasping the switch toggle (B) Fig. 16, and pulling it out of the switch, as shown. With the switch toggle (B) removed, the switch will not operate. However, should the switch toggle be removed while the machine is running, the switch can be turned “OFF” once, but cannot be restarted without inserting the switch toggle (B).

B

Fig. 16

OPENING AND CLOSING DOOR

When making adjustments such as changing the blade, tracking the blade, blade guide adjustments, etc., the door (B) Figs. 17 and 18, can be opened as follows:

WARNING: MOVING PARTS. LAZERATION / PINCH HAZARD: NEVER OPEN THE DOOR WHEN THE MACHINE IS RUNNING.

1.Press in the two locking latches (A) Fig. 17, and swing door (B) open.

2.Fig. 18, illustrates door (B) in open position.

3.To close and fasten door (B) Figs. 17 and 18, press on door directly over latches (A) Fig. 17, until latches snap into the locking position.

B

A

Fig. 17

B

Fig. 18

10