Black & Decker BDBS100 instruction manual

6.Locate pinion knob (N) Fig. 9, spring (O), and special screw (P).

7.Position pinion knob (N) Fig. 10, onto the back of saw so that the teeth on the pinion knob (N) engage the teeth on the trunnion (R). Fasten in place with special screw (P) and spring using the supplied 4mm wrench.

8.Fasten pointer (S) Fig. 11, to the back of band saw using the M5x.8x10mm pan head screw (T).

9.Place locking handle (F) Fig. 4, onto stud (G). Place spring (E) Fig. 4, inside hole of lock handle and fasten in place with screw (D) as shown in Fig. 11. NOTE: Handle (F) is spring-loaded and can be repositioned on the stud by pulling out the handle and repositioning it on the nut.

10.Insert M6x1x30mm screw (W) Fig. 12, down through hole in table, as shown, and place an M6 flat washer (Z) onto the M6x1x30mm screw (W) and thread the M6x1 wing nut (X) onto screw (W) and tighten securely.

N

O

P

Fig. 9

R

P

N

Fig. 10

D

F

S

T

Fig. 11

W

Z

X

Fig. 12

8